chinaenglish

NEWS

CONTACT US

TeL:0086-27-83341455
Ella:0086-18702715855
Fax:0086-27-83364186
Email:sales@hasary.com
MSN:hasarylaser@hotmail.com

Laser Machine FAQ
Your current location: Home >> Laser Machine FAQ

laser cutting machine for Basswood
Published:2013-10-11 Browse: Font size[ Large medium small ]

                            laser cutting machine for Basswood
Basswood is a soft wood with tight grains. Its relatively inexpensive of all the usual guitar woods, and it’s easy on router bits in the factory, easy to sand, and easy to seal and finish. The softness of basswood means that sharp highs are dampened and smoothened. That helps offset the tinny sound associated with knife edged tremolo contacts. The softness also fosters a weaker low end. It’s light in weight, but not because of large pores. Rather it’s low in mass overall. Deep, breathy sub-lows aren’t resonated in Basswood. The reduction in these outer frequencies leaves the mids pronounced in a hypothetical response curve. Its very suitable for the typical guitar range, and very suitable for lead guitar, because of its pronounced “out front” sound. Complex overtones are muted along with the highs leaving a strong fundamental tone.

Production notes:  A clearer, darker Basswood should produce more sound, while the yellowish lower grade seems to have more of the undesirable tonal qualities of Poplar. A hardtail emphasizes the reduced dynamics of the outer frequencies.

『 Pre』 Laser cutting machine for Walnut and Mahogany     『Next 』 Laser cutting machine for acrylic

在线客服
在线客服系统