Laser Machine FAQ
Your current location: Home >> Laser Machine FAQ

Laser cutting machine for Walnut and Mahogany
Published:2013-10-14 Browse: Font size[ Large medium small ]

                     Laser cutting machine for Walnut and Mahogany

A darker wood with Ash-like grains, but like mahogany, the density is uniform. It is harder and denser than Mahogany so the tone is brighter, but the open grains make for a complex midrange that seems to be compressed in some frequencies, but dynamic in others. There’s a nasal response to rhythms, while solo notes jump out. It has a lot of advantageous features of the other main guitar woods. It has a snappy attack and solid lows like Ash, but with smooth highs like Mahogany, and textured mids like Alder. The drawbacks are that it’s heavier, and more stubborn in its sound. It doesn’t respond to random pickup changes. The pickups have to be well suited to the guitar. A Walnut body will dictate the tonal signature of the guitar more than the other main woods. A heavy piece will dampen the mids to produce an overly nasal and lifeless sound, so it needs to be light and open grained enough to resonate the main guitar frequencies.

Production notes: Again watch for heavy pieces. The extra weight adds nothing good to the sound except perhaps more sustain. But sustain is abundant in Walnut already.


Open grained with large pores, Mahogany has a more uniform grain pattern and density than Swamp Ash. Its density is constant within the ring and from one ring to the next. So it’s rigidity is inherent in its composition, not in a “skeleton” with soft sections in between. It’s constant density compresses the mids a little, and this can be considered a thick sound, because it does still produce good lows and low mids. Without the mids popping out, being responsive to dynamics, its more of a “wall of sound” Its not that it isn’t midrangey, because it resonates those guitar frequencies well, but its not as responsive to them as an Alder or Ash. It also combs away more upper midrange frequencies for a more nasal sound. It has a good balance of fundamental and overtones for higher register soloing. High notes are richer and thicker than Alder or Ash.

Production notes: There are many different kinds of Mahogany, and unless it has a sparkle to it like some of the Japanese and US guitars it will have a similar sound from one piece to the next. A nicer piece of mahogany has an iridescence to it usually combined with what looks like wide stripes, almost as if it’s been pieced together by multiple 1” strips. Catalog photos often reveal that the endorser gets a better piece than the production line.

『 Pre』co2 laser marking machine     『Next 』laser cutting machine for Basswood